Breville Steam Iron Manuel d'utilisateur Page 7

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 16
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 6
7
using your iron
Ironing without steam
If you intend to dry-iron fabrics there is no need to ll the water tank. However, if water is
already in the water tank, you don’t need to empty it.
Set the steam control to the no steam position ( ) position.
Plug your iron into the mains supply and switch on.
Rotate the temperature control dial until the desired setting is aligned with the
indicator light/dial pointer.
The temperature indicator light will illuminate while your iron is heating up. When the
light goes out, your iron is ready to use.
Steam ironing
During steam ironing, if you do not allow your iron to reach the selected
temperature water may drip from the soleplate.
It is recommended that for harder to iron fabrics such as cotton and linen, steam should
be used when ironing.
When ironing cotton and linen, always select the highest temperature. Steam should
never be used on delicate fabrics like nylons, acrylics and synthetics.
Fill your iron with water.
Plug your iron into the mains supply and switch on.
Set the temperature control dial so it is within the steam range (
ll
or
lll
). The
hotter your iron, the more steam is generated.
The temperature indicator light will illuminate. When the temperature indicator light
goes out your iron is ready to use. The temperature indicator light will turn on and off
during ironing as your iron maintains the correct temperature.
Adjust the steam control lever to select the desired steam output.
Move the steam control lever backwards to increase the amount of steam, or
forwards to decrease the amount of steam.
The steam can be shut off at any time by setting the steam control to the no steam
( ) position.
Burst of steam
The temperature control dial must be set within the
ll
and
lll
setting. Wait several
seconds between each press of the steam button.
Press the shot of steam button whenever you have a stubborn crease that needs extra
steam. Steam will burst from the holes in the soleplate of your iron into the fabric.
1.
2.
3.
4.
1.
2.
3.
4.
5.
6.
7.
Vue de la page 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Commentaires sur ces manuels

Pas de commentaire